 |
|
QB-50
VDM, QB-50 VDE
- QB50 available
in either VDM (shown) using a manual hand wheel for positioning
of the CB (counterbend die), or VDE model which
incorporates motorized CB die positioning.
- Maximum capacity: up
to 2" OD tube (mild steel, .125" wall thickness).
Wide range of bend radii available from 3/8" to 8-3/4"
CLR.
- Tooling available to
bend round, square, rectangular tube, and profiles or special
shapes.
- Variable bending speed:
adjusted by potentiometer on control panel (>/=11.5 seconds
for 180°). Allows operator to set required speed for various material;
i.e stainless and chromoly require slow speed settings.
- Microprocessor Control
Unit: bending angle, springback factor, and zero position
of counterbend die shaft (VDE model only) are fully programmable
and monitored thru the control panel.
- User friendly programming:
easy step by step method. Capable of storing up to 10 sequential
bends.
- Electronic overload
device: automatically protects the mechanical system from
possible damage caused by oversized material and / or excessive
bend speed.
- Multilanguage control
panel with backlit LCD display enhances ease of operating
and programming.
- Low maintenance:
requires lubrication of counterbend die only.
- Quick change tooling.
- Portable: built
in wheels and extractable handles.
- Available in single
phase, or three phase with multiple voltage settings.
- Positioning
Table available (QPPT)
|
|
|
